Plug-In DIY X10 Lamp Module Receiver

- Control your plug-in light with your home control system.
- Switches and dims lighting loads up to 300W.
- Suitable for resistive loads (240V light bulbs) and low voltage lighting with dimmable transformers.

The LM12 lamp module is a dimmable X10 home control receiver that installs simply by plugging it into a power point. A lamp or other light fitting rated between 40 and 300 Watts is then connected to the lamp module, proving you with control of that light from your home control system.

The LM12 is not suitable for fluorescent, low-energy lights or appliances as attempting to dim these devices may damage the lamp module or the device. For such applications you can use the AM12 appliance receiver (On/Off only), or other suitable appliance receiver.

The LM12 lamp module responds to X10 signals such as ‘On’, ‘Off’, ‘Dim’, ‘Bright’ ‘All Off’ and ‘All Lights On’. The lamp module's X10 address set using the two dials on the front, which set the module's House Code and Unit Code.

This product includes insulated pins and has been tested and approved to Australian/New Zealand regulatory standards.

Technical Specifications

• Supply voltage: 230 V +/-10% 50 Hz
• Supply current: 20 mA capacitive
• Making capacity: 60 to 300 W (incandescent, and 12 V halogen lamps only)
• Regulating time: 4,4 sec +/- 0.2sec from fully on to off
• EMC emission: According to EN 50081-1 EMC immunity: According to EN 50082-1 Electrical safety: According to EN 60950 and EN 60065 Signal sensitivity: 15 mVpp min 50 mVpp max at 120 kHz Input impedance: 55 W (L - N) at 120 kHz
• Ambient temperature: - 10 degrees C to + 50 degrees C (operation) - 20 degrees C to + 70 degrees C (storage)
• Dimensions: 52 x 122 x 33 mm (width x height x depth without plug)