Wired-In X10 Appliance Module Receiver

The wired appliance module receives X10 signals sent through the power lines by your X10 home control transmitters and interfaces. Requiring professional installation, it can be built in or wired to the appliance you wish to control. This module can be used to add remote and/or automated control to appliances or on/off lighting in your home.

Here are just some of the devices can be automated using the Appliance Module:

- Air conditioners
- Heaters
- Fountains & pool pumps
- Heated towel rails
- Electric blankets
- Ceiling fans

How it works:

Your electrician will connect the wired appliance module to the 240V supply, then connect the appliance you want to control to the module. The appliance module's X10 address is set via the two dials on the front of the module and you're ready...it's that easy!

• Turn your appliances on and off no matter where you are in the house.
• Controls any 240V appliance up to 10A resistive load, 1A inductive load.

Note: The wired appliance module can only be controlled using X10, if you still require a manual control switch, see our AD10, SAIX or AW12 receivers.