Fibaro Z-Wave Micro Dimmer 2 (FGD-212)

Smart Home posted this on 12/06/2018

Familiarise yourself with your Micro Dimmer 2.

 

Fibaro Z-Wave Micro Dimmer 2 (FGD-212)

 
  • L – Terminal for live lead.
  • S1 – Terminal for switch number 1 (has the option of entering the device in learning mode).
  • S2 – Terminal for switch number 2.
  • Sx – power output terminal for connected switch(es).
  • N – Terminal for neutral lead .
  • OUT – output terminal of the Dimmer 2 (controlling connected light source)
  • B – service button (used to add/remove the device and navigate the menu).
 

Micro Dimmer 2 wiring diagrams.

 

Micro Dimmer 2 wiring diagram without neutral

 

WARNING

 

Must be installed by a licensed electrician.

 
 

Fibaro Z-Wave Micro Dimmer 2 (FGD-212)

 
 

Micro Dimmer 2 wiring diagram with neutral

 

WARNING

 

Must be installed by a licensed electrician.

 
 

Fibaro Z-Wave Micro Dimmer 2 (FGD-212)

 
 

Arranging the antenna.

 

Locate the antenna as far from metal elements as possible (connecting wires, bracket rings, etc.) in order to prevent interferences.

 

Metal surfaces in the direct vicinity of the antenna (e.g. flush mounted metal boxes, metal door frames) may impair signal reception!

 

Do not cut or shorten the antenna – its length is perfectly matched to the band in which the system operates.

 

Adding Micro Motor Controller to your Z-Wave controller.

 

Adding your Micro Dimmer 2 to a Z-Wave network.

 

1. Place the Dimmer 2 within the direct range of your Z-Wave controller.

 

2. Identify switch no. 1 (turns the light on) or the B-button (located on the device’s housing).

 

3. Set the main controller in (security/non-security) add mode (see the controller’s manual).

 

4. Quickly, three times press switch no. 1 or the B-button.

 

5. Wait for the adding process to end.

 

6. Successful adding will be confirmed by the Z-Wave controller’s message.

 
 

Removing your Micro Dimmer 2 from Z-Wave network.

 

1. Place the Dimmer 2 within the direct range of your Z-Wave controller.

 

2. Identify switch no. 1 (turns the light on) or the B-button (located on the device’s housing).

 

3. Set the main controller in remove mode (see the controller’s manual).

 

4. Quickly, three times press switch no. 1 or the B-button.

 

5. Wait for the adding process to end.

 

6. Successful removing will be confirmed by the Z-Wave controller’s message.

 
 

Reseting your Micro Dimmer 2.

 

Reset procedure ereses memory of the device, including all information on energy consumption, calibration, the Z-Wave network and the main controller.

 

1. Disconnect the power supply.

 

2. Remove the Dimmer 2 from the wall switch box.

 

3. Connect the power supply.

 

4. Locate the B-button on the housing.

 

5. Press and hold the B-button to enter the menu mode.

 

6. Wait for the visual LED indicator to turn yellow.

 

7. Quickly release and click the B-button again.

 

8. After few seconds the device will be restarted, which is signalled with the red LED indicator colour.

 

9. The device enters the calibration mode.

 
 
Categories: Z-Wave
Tags: z-wave  lighting  fibaro  dimmer