The incredibly small Fibaro Smart Implant allows you to enhance the functionality of appliances, alarm systems, garage doors and more by adding the power of Z-Wave to otherwise “dumb” devices by opening/closing two independent low-voltage “dry-contact” outputs. You can also connect up to two compatible binary / analog input sensors to have them report their readings back to your Z-Wave controller.
The Fibaro Motion Sensor is a universal Z-Wave motion, temperature, light and vibration sensor flawlessly crafted into a single multi-sensor around the size of a golf ball. The Fibaro Motion Sensor is a battery powered device that is designed to be installed easily on any surface.
Fibaro Door/Window Sensor 2 is a wireless, battery powered, Z-Wave Plus compatible magnetic contact sensor. Opening is detected by separating the sensor’s body and the magnet. Sensor can be used to trigger scenes and wherever there is a need for information about opening or closing of doors, windows, garage doors, etc. In addition, the Fibaro Door/Window Sensor 2 is equipped with a built-in temperature sensor.
The Fibaro Flood Sensor can be placed on the floor where deployed probes will detect water below the device, or it can be wall mounted where an extended wire probe can be used to monitor from a distance. The sensor can be battery or mains powered, has a built in LED indicator / acoustic alarm and a tilt sensor that allows it to notify you when its being tampered with. Water detection is displayed as a notification or via the LED light, which doubles up as a Z-Wave network communication range indicator.
Use this Recessor to place Fibaro Motion Sensors within a wall or ceiling allowing them to serve their function more discreetly and preserving the aesthetic appeal of your home. It is easy to install and remove. Simply twist the cover off the Recessor and place your Fibaro Motion Sensor inside, then pull the Recessor clips back as you insert it into the hole in your wall/ceiling.