A new generation of Z-Wave micro relays.
Featuring the latest Z-Wave Plus 500 Series chipset... further, faster and more secure.
A 50% increase in wireless range thanks to the latest 500 Series Z-Wave Plus chipset.
New larger wire terminals allow for faster and easier installation - saving time and money.
A built-in RGB configuration LED further simplifies the installation process.
Now supports wireless "Over-the-Air" firmware updates via compatible Z-Wave controllers.
Works with virtually any switch.
Easily installs behind your exisiting switch - maintaining traditional wall-switch control whilst adding intelligent Z-Wave control.
You are free to express yourself and use almost any switch you like (or none at all). Compatible with momentary, toggle, 2-way or 3-way switches.
You are in total control.
(and always well informed).
You can control the Single Switch 2 and receive information through your personal computers and mobile devices.
Measure and log the energy used by the connected load to help reduce your power bills and save money.
The Fibaro Single Switch 2 allows you to cut the power supply to domestic appliance when they are not in use.
Your home is wherever you are.
Like the entire Fibaro Z-Wave system, the Single Switch 2 module can be controlled from anywhere on earth. All you need is an internet connection.
Appliance power monitoring.
Define minimum and maximum energy consumption limits and receive a notification if a limit is reached.
Notification of unused appliances.
Trigger a notification if you leave a device running for too long... and turn it off remotely.
Protection from sudden voltage drops, overheating or overloading. If one of these events occurs, the system will immediately send you a notification.
The finer details
This module requires both active and neutral wires.
The output is not free from charge - It therefore does not enable a dry contact or a load to be control with any power voltage other than the input.
Please see the older Fibaro FGS-211 for dry contact compatibility.
- Radio Protocol: Z-Wave Plus 921Mhz (Approved Aus. / NZ)
- Radio signal power: up to 1mW.
- Range: up to 50m (outdoors) and 40m (indoors).
- Voltage: 110 - 240V AC.
- Maximum load: 8A (Resistive).
- Power Consumption: < 0.8W.
- Supports secure mode wireless encryption with AES-128.
- Operation temperature: 0 ~ 55 °C.
- Weight: 50g.
- Dimensions: 42mm x 37mm x 17mm.
- Compliance: EN 55015, EN 60669-2-1.
- Regulatory Compliance Mark: N5496.
|Name||Fibaro Z-Wave Single Switch 2|
|Product Manual||Fibaro Z-Wave Single Switch 2 Product Manual|
|Warranty||12 Months (+ Free 12 month extended warranty)|