Questions about Aeotec Z-Wave Garage Door Controller

<< Back to the product page
 
From Martin on 09/04/2019

Q: Would this work with the RACV Samsung Smarthings Hub?

A: Yes :)

(22 votes)


Helpful Helpful Not helpful Not Helpful
From Tristan on 15/12/2018

Q: I have been holding out for a garage door opener in Australia that is supported by HomeKit for a couple of years, but it looks like I'm going to have to piece it together myself.

Can I get an idea of what kind of garage door opener I should buy to go with this controller and anything else I would need to bridge it to HomeKit? I only have HomeKit products so far.

A: You will need a Z-Wave "Hub" (Vera Plus is a good entry level controller) to work with AutomationBridge. The good news is you will also be able to include other Z-Wave devices as part of HomeKit.

(52 votes)


Helpful Helpful Not helpful Not Helpful
From Jim on 22/11/2018

Q: Does this accessory work with a Vera lite?

A: As long as you are running UI7, it will work perfectly.

(70 votes)


Helpful Helpful Not helpful Not Helpful
From Amos Findlay on 05/11/2018

Q: I have 3 garage doors, I assume I will need 3 controllers?

A: Yes, that is correct.

(86 votes)


Helpful Helpful Not helpful Not Helpful
From Andy on 04/10/2018

Q: Does this controller support dry contact ? That is the two cables from this Aeotec controller goes to my dry contact in garage opener ?

A: Yes, the Aeotec Garage Door Controller uses the dry contact connection on your garage door motor.

(97 votes)


Helpful Helpful Not helpful Not Helpful
From Glen Kennedy on 20/09/2018

Q: Will this product work with the VeraPlus Home Controller unit?

A: Yes - it works very well with the VeraPlus.

(116 votes)


Helpful Helpful Not helpful Not Helpful
From Chris Hosking on 06/09/2018

Q: Where do you mount the sensor if you have a roll-a-door instead of a panel door?
The panel door you need to mount it at the top, middle or left or right side.
Can you mount it at the bottom of the roll-a-door?

A: At the bottom of the roller door - being carful that it does not roll onto the sensor. It will take a bit of trial and error - but it will work.

(116 votes)


Helpful Helpful Not helpful Not Helpful
From John Hardy on 05/11/2016

Q: Unsure how to hook up to Merlin ProLift 230T. Any advice please?

A: Hi John,

Please consult the manual for your garage door opener - what we are looking for is the low-voltage terminals that would normally connect to a wall switch (usually a bell press button). I hope this helps.

(569 votes)


Helpful Helpful Not helpful Not Helpful

Ask A New Question

* Required Fields