Aeotec Nano Dimmer is a Z-Wave smart dimmer specifically used to enable Z-Wave command and control (on/off/dim) of connected dimmable lighting via a Z-Wave compatible hub or software. It can report immediate wattage consumption or kWh energy usage over a period of time. In the event of power failure, non-volatile memory retains all programmed information relating to the unit’s operating status. Nano Dimmer can connect to 1 or 2 external switches to control the connected lighting manually.
Advanced wiring diagrams
IMPORTANT – All 240V electrical work and installations in Australia must be performed by a licensed electrician. The wiring diagrams below are for informational purposes only.
Single Switch
Two-Way Switch
Multi-Way Switch (using “Momentary Bell Press” switch mechs).
Wall-switch calibration
Switch connected to S1
Press the “Action” button on the Nano Dimmer 4 times quickly – the LED on the Nano Dimmer will start flashing green. Now flick the attached standard latching light switch once OR quickly press and release the attached momentary switch. Wait about 20 seconds and the Nano Dimmer should now be calibrated to work correctly with the attached switch.
Switch connected to S2
